RPI Automation 2.1.1 - Get Apk

---

About RPI Automation

Use this app to control Raspberry Pi GPIO outputs, and view the status of 1 input. You must first have a Raspberry Pi with Webiopi installed and setup. Each button can be set to operate a different IP address, port...

Use this app to control Raspberry Pi GPIO outputs, and view the status of 1 input. You must first have a Raspberry Pi with Webiopi installed and setup. Each button can be set to operate a different IP address, port number, GPIO pin, as well as use any button as a momentary push button (low then high, or high then low) for operating actuators for door locks, or garage doors. You can also setup the button to go high and stay high, or low and stay low for turning lights on and off as well as set the duration so you could say turn a light on for 5 minutes then turn it off. There are up to 12 buttons available, and only show up when enabled. Use the input connected to a switch to detect a door open condition or what ever you like! (No authentication, must # out password in config file for webiopi etc/webiopi/config)

---

Previous Versions

Here you can find the changelog of RPI Automation since it was posted on our website on 2016-10-17 18:47:54. The latest version is 2.1.1 and it was updated on 2024-04-22 15:26:04. See below the changes in each version.

---

Related Apps

Here you can find apps that are similar with RPI Automation.

---

Disclaimer